Major retailers pull ionisation smoke alarms
19 June 2018
Major retailers pull ionisation smoke alarms following Consumer NZ report
All major DIY stores have agreed to stop selling ionisation smoke alarms following a request from Consumer NZ.
A recent Consumer NZ test of smoke alarms found ionisation-type smoke alarms performed so poorly that the watchdog called for retailers to pull them from their shelves. The organisation is pleased to report all stores contacted about their ionisation alarms agreed to stop selling them.
Mitre10 and Hammer Hardware said they would “cease selling ionisation smoke alarms, effective immediately”.
PlaceMakers said it would “exit the balance of our ionisation alarms, which we anticipate will be completed within a matter of weeks”.
Bunnings Warehouse said “our intention is to sell through our ionisation smoke alarm stock and no longer sell that product”.
Consumer NZ head of testing Dr Paul Smith welcomed the news.
“Removing a product that doesn’t perform a critical safety task effectively is a major win for New Zealand consumers,” Dr Smith said.
Why not ionisation?
Ionisation alarms give much less warning of smouldering fires (such as those caused by faulty electrical wiring, curtains draped over a heater, or a hot ember igniting upholstery foam) making it less likely you can get out of your home safely.
All smoke alarms will respond to a fire, eventually. “The difference is whether they respond to visible smoke. A smouldering fire can fill a home with deadly smoke long before it bursts into flames,” Dr Smith said.
Consumer NZ testing confirmed ionisation models were great at detecting flaming fires, but not so good with visible smoke. “The four ionisation alarms in our test were faster at detecting flaming fires (burning oil and wood) but much slower at detecting smoke from smouldering foam.”
People should check which type of smoke alarm they have in their homes and rental properties. “You can identify an ionisation alarm from a radioactive symbol somewhere on the alarm body – it may be underneath, so you might need to remove it to check.”
Consumer NZ advises people:
• Not to remove working ionisation alarms – any alarm is better than no alarm.
• If only ionisation alarms are fitted, you should also fit photoelectric models at least in hallways and escape routes.
For rental properties:
• Landlords must ensure working smoke alarms are installed at the start of a tenancy. Existing ionisation alarms can stay where they are, but all new smoke alarms must be photoelectric models with a long-life battery.
• Tenants must not remove smoke alarms, and are responsible for replacing dead batteries.
To see which photoelectric models performed well, visit consumer.org.nz.
About Consumer NZ’s test
Our test, based on the
UL217 standard for smoke alarms, was conducted at an
independent lab. Multiple alarms were placed in our
“smoke-sensitivity chamber”. Smoke was introduced from
flaming wood, flaming oil, smouldering wood chips, and
smouldering upholstery foam. We tested three samples of each
alarm model and assessed their response to smoke compared to
three control sensors.